View shopping cart
0 Products  
0,00 €    

0save cart

View wish list
0 Products  

0add wishlist

Go to product comparison
0 Products  

0add compare

Workshop equipment

InoTec SB 20 kg

Sample image, your configuration may differ.

Description

  • Pickling stainless steel surfaces and weld areas in a single operation
  • A clean metallic surface is achieved in the application zone
  • Development of nitrous gases reduced by up to 80%
  • Weld seams and heat-affected zones must be allowed to cool before treatment
  • Surfaces must be free of grease and organic contaminants
  • Do not use in direct sunlight, wind and temperatures below +10 °C or temperatures above 25 °C
  • Flush with water under high pressure (min. 140 bar)
  • Please note: Use of colour indicator (KMNO4 – potassium permanganate) not possible!
Note
  • Contains hydrofluoric acid and nitric acid
  • Disposal regulations must be observed; do not discharge into any waterway, sewer or drain
  • * Application time depends on material quality and the temperature of the components and surroundings The optimum etching temperature is 18–22 °C

Technical data

Yield4 - 6 m²/kg
ApplicationApply to the surfaces to be treated using the IK Multi 1.5 (398-003163-00000) or IK Multi 9 (398-003164-00000) pickling spray pump
Reaction time*45 min - 150 min
Finishing treatmentInoTec passivating agent for immediate formation of the passive layer
Weight20 kg
Packing drumCanisters
UN number2922

Documents

An error occurred
Successfully completed
current mapping: product